Install Document

Have a Sales Question ???
Get Instant help online from our
trained sales electronics specialists.

L. INSTALLING THE CAP MOUNT ONTO THE ANTENNA REFLECTOR

Perform the following steps to assemble the antenna reflector onto the azimuth/elevation (AZ/EL) cap mount.

1. Insert the four threaded studs on back of antenna reflector through corresponding holes on AZ/EL cap mount assembly (see diagram at right).

2. Install four lock washers and 5 /16 -inch hex nuts onto threaded studs. Tighten and torque hex nuts to 18 ft.-lbs. (24 N-m).

M. INSTALLING THE ANTENNA/CAP MOUNT ONTO MAST

Perform the following steps to assemble the antenna/cap mount onto the NPM mast. Note: Do not remove the abrasive pad from inside the cap mount assembly; it remains as a part of the assembly.

1. Lift antenna/cap mount assembly and slide AZ/EL cap mount onto mast tube (see diagram at right). Face of antenna should be parallel to front of base.

2. Tighten 5 /16 clamp nuts so that the antenna/cap mount assembly is held stationary on mast but can be swiveled with slight pressure.

[Page 1] [Page 2] [Page 3] [Page 4] [Page 5] [Page 6]

[Page 7] [Page 8] [Page 9] [Page 10] [Page 11] [Page12]

[Page 13] [Page 14] [Page 15] [Page 16] [Page 17] [Page 18] [Page 19]

DirecPC is a product and service of Hughes Network Systems, a Hughes Electronics (GMH) company. Hughes Network Systems also manufactures DirecDuo and HNS Brand DIRECTV System.

Copyright 2000, Hughes Network Systems, Inc. , a Hughes Electronics Corporation company. DirecPC is a registered trademark of Hughes Network Systems, Inc. Turbo Internet, Turbo Webcast, and Package Delivery are trademarks of Hughes Network Systems, Inc. All other trademarks are the property of their respective owners.